Fix Ricoh Error SC400: Transfer Belt Error
warning Severity: warning
If your Ricoh printer is displaying error SC400, do not worry – this is a known issue with a proven fix. This error typically indicates transfer belt error that can usually be resolved without a service call. Follow the steps below to clear this error.
What Causes Ricoh Error SC400?
This error can be triggered by one or more of the following issues:
- Transfer belt unit worn or damaged
- Transfer belt not seated correctly
- Transfer belt roller contamination
- Transfer belt motor error
How to Fix Ricoh Error SC400
Follow these steps in order. After each step, check whether the error has cleared before proceeding to the next one.
- Step 1: Open the front cover and check the transfer belt installation
- Step 2: Remove and reseat the transfer belt unit
- Step 3: Check for toner contamination on the belt surface
- Step 4: If the belt is worn or damaged, replace it
- Step 5: Clean the belt gently with a dry lint-free cloth if contaminated
- Step 6: Power cycle after reseating
Affected Ricoh Printer Models
The following Ricoh printer models are known to display error SC400:
Related Ricoh Error Codes
If you are troubleshooting error SC400, these related error codes may also be relevant:
- SC542 – Fuser Heater Error
- SC543 – Fuser Overheat Error
- SC544 – Fuser Temperature Sensor Error
- SC670 – Main Drive Motor Error
- SC541 – Fuser Low Temperature
Frequently Asked Questions
What is Ricoh error SC400?
SC400 indicates a problem with the intermediate transfer belt. The belt may be worn, improperly installed, or its motor may have malfunctioned.
How long does a Ricoh transfer belt last?
Transfer belts on Ricoh printers typically last 80,000-120,000 pages. Check the supplies counter through User Tools for remaining life.
Error still not resolved?
If the steps above did not fix the error, the issue may require professional service. Contact the manufacturer support line or visit an authorized service center near you.