Fix Ricoh Error SC440: Transfer Roller Error
warning Severity: warning
If your Ricoh printer is displaying error SC440, do not worry – this is a known issue with a proven fix. This error typically indicates transfer roller error that can usually be resolved without a service call. Follow the steps below to clear this error.
What Causes Ricoh Error SC440?
This error can be triggered by one or more of the following issues:
- Transfer roller bias voltage error
- Transfer roller dirty or worn
- Transfer roller connection loose
How to Fix Ricoh Error SC440
Follow these steps in order. After each step, check whether the error has cleared before proceeding to the next one.
- Step 1: Remove and reseat the transfer roller
- Step 2: Clean the transfer roller surface
- Step 3: Check the roller electrical contacts
- Step 4: Replace the transfer roller if worn
- Step 5: Power cycle the printer
Affected Ricoh Printer Models
The following Ricoh printer models are known to display error SC440:
Related Ricoh Error Codes
If you are troubleshooting error SC440, these related error codes may also be relevant:
- SC542 – Fuser Heater Error
- SC543 – Fuser Overheat Error
- SC544 – Fuser Temperature Sensor Error
- SC670 – Main Drive Motor Error
- SC400 – Transfer Belt Error
Frequently Asked Questions
What is SC440?
SC440 indicates a problem with the transfer roller, which transfers toner from the drum to paper. It may be dirty, worn, or have an electrical connection issue.
How do I replace a Ricoh transfer roller?
Open the front cover, locate the transfer roller below the drum, release the lock tabs, and slide the roller out. Install the new roller and lock it in place.
Error still not resolved?
If the steps above did not fix the error, the issue may require professional service. Contact the manufacturer support line or visit an authorized service center near you.